Introduction

Step 1 - Estimate

Step 2 - Contract

Step 3 - Installation

Step 4 - Follow up

Step 3 - Installation

---

Red "Rain Man" flags on a lawn

Before we start digging, we use flags to mark the locations of sprinkler heads and valve boxes. Any last minute changes are usually made at this point. Typical installations take 1 - 3 days to be completed.

Pulling pipe behind a tree

Next we pull/plow in the pipe. We try to minimize any trenching under walkways pathways and go around the house, instead of under a driveway.

After the pipe is in the ground, we install the main controller and rain sensor (usually in the garage)

The last step is to attach the valves and sprinklers, clean up the site and go over the system.

Finished system, one month after installation